SE-R/G20 HEAD/Valve Train


JWT Cams for SR20 Motor.
S3 .442" 260 Deg- $549
S3m .442" 260 Deg- $549 (for GTi-R)
S3 Roller .442" 260 Deg- $549 (for roller rocker motors)
S4 .464" 266 Deg- $549
S4m .464" 266 Deg- $549 (for GTi-R)
S5 .503" 281 Deg- $549
C1 .476" 264 Deg- $549
C2 .500" 275 Deg- $549
c3 .526" 285 Deg- $549


Greddy 1.2mm head gasket for SR20 Motors $189


Greddy SR20 Valve Springs (will not fit GTI-R motors) $161


Cometic 1.1mm metal head gasket for SR20 - $99


JWT Valve Spring titanium retainer combo, for use with (C) series cams. Will not work on GTI-R - $499


Crower Titanium Retainers - Replace the stockers with these lightweight units from crower - $163


Greddy Rocker Arm Stoppers, allow you to rev higher than stock without risk of kicking off rocker arms. A common problem on SR20's. A finger rests above each of the eight rocker arms if they've began to float and raise then they hit the finger and this keeps them from coming off their seat and causing catastrophic engine failure. - $66.00


Greddy cam gears. These allow more adjustment than the JWT cam gears and are priced to sell. $109.20 each


JWT SR20 Cam Gears FWD - Exhaust $140 / Intake - $140


JGYCustoms Valve Clearance Measuring Service. SR20 Valve trains are hydraulic but they still require the use of shims to keep the rocker arm level on both sides. After a valve job is performed or a new valve is installed these shims must be precision measured and replaced as needed. Failure to do so results in rapid cam and rocker arm wear and possible damage to motor. $100